11/10/2022 0 Comments Lancair iv flight sim p3d![]() ![]() We'll continue to tweak/improve it wherever possible. Allowing roll mode to engage outside of those constraints causes even less predictable behaviour. Roll mode only engaging when the roll knob is centred, the aircraft is banked less than 10 degrees and the roll rate is low is a mixture of real-world AP logic and attempts to tame the unpredictable MSFS AP system. I'll have to see if there is a way to add some 'smoothing' code for the yoke but either way hopefully this is a minor sacrifice in realism. This logic was used as the PID used for roll control causes lots of small fluctuations in the position of the ailerons that is not very noticeable on the exterior model but looks odd and distracting when shown by the yoke position, which 'flickers' and doesn't necessarily show a logical position for the selected bank. So the only thing we're sure is wrong in is the yoke tied to the roll knob instead of the ailerons? I'll let you raise a support ticket, Nick, as you picked it up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |